Rki-instruments Beacon 200 RIg Monitor, H2S/H2S Manuel d'utilisateur télécharger pdf (Page 37)

Beacon 200 Rig Monitor Operator’s Manual • 32

Chapter 6: Maintenance

Overview

This chapter describes use of the Calibration Program and corrective

maintenance procedures for the Beacon 200 Rig Monitor. It includes a

troubleshooting guide for problems you may encounter with the Beacon

200 Rig Monitor. Procedures to replace components of the Rig Monitor are

at the end of this chapter.

Calibration Program

The Calibration Program is used to calibrate the Rig Monitor’s active

channel(s).

Calibration Program Flow

Figure 11 below illustrates the general flow of the Calibration Program. See

the next section, Preparing for Calibration, for instructions to enter the

Calibration Program. In general, the program screens provide instructions

to guide you through the program. At any point in the calibration program,

the ESCAPE key may be used to either return to the previous screen or

abort a process.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 50 51

Pas de commentaire

Rki-instruments Beacon 200 RIg Monitor, H2S/H2S Manuel d'utilisateur Page 37