Rki-instruments GX-2009 Manuel d'utilisateur télécharger pdf (Page 38)

38 • Setting Commands

When you upload a parameter configuration file to an

instrument, you are uploading instrument parameters such as

alarm points, alarm pattern, calibration frequency, etc.

Uploading a parameter configuration file to an instrument will

not change the instrument identification parameters, serial

number, user ID, and station ID, if the file was created from a

different instrument.

Follow these steps to load a parameter configuration file to the

program and upload it to an instrument:

1. Launch the GX-2009 User Setup Program as described in

“Launching the Program” on page 14.

2. Connect the GX-2009 to the User Setup Program as

described in “Connecting a GX-2009 to the User Setup

Program” on page 15.

NOTE: It is not necessary to use Instrument Information or

Instrument Get & Save in order to load a parameter

configuration file and upload it to an instrument.

Although it is not necessary to use Instrument

Information or Instrument Get & Save before loading

a file and uploading it to an instrument, you can do so

after using either of these functions if desired.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Pas de commentaire

Rki-instruments GX-2009 Manuel d'utilisateur Page 38